Instructions for assembling hookah Rico

Set
: 1 – diffuser,
2 – submersible part of the pipe,
3 – pipe sealer,
4 – base,
5 – hose connector on the “o-ring” system.,
6 – decorative stem sleeve on the pipe,
7 – pipe top,
8 – tray,
9 –bowl connector,
10 – bowl seal,
11 – purge valve balls.

Before the first use, be sure to rinse all parts and accessories of the hookah. We recommend that you clean all holes and threaded connections with a brush using baking soda; Rinse the vase and hose with running water.

Start collecting the hookah should be from the bottom and move up.

• Connect the submersible part of the pipe (part number 2) to the diffuser (part number 1);
• We screw the submersible part connected to the diffuser (parts no. 1 and 2) into the base of the shaft (part no. 4).
• In the base of the hookah (part number 4) we put balls for the purge valve 7 pcs (part number 11);
• We wind the upper part of the pipe (part number 7) onto the base of the pipe (part number 4);
• We wind the decorative stem sleeve on the pipe (part number 6) onto the base of the pipe (part number 4);
• The tray (part number 8) is installed on the upper part of the pipe (part number 7); Then, we screw the connector for the bowl (part number 9) into the upper part of the pipe (part number 7);
• We install seals for the vase (part number 3) and the bowl (part number 10);
• To start smoking, insert the pipe into a vase filled with water. The lower part of the pipe should be 1-2 centimeters immersed in water. A silicone hose with a mouthpiece is inserted into the hose connector. Hookah “RIKO” is fully assembled.

IMPORTANT!!! To make the hookah last as long as possible, we recommend rinsing the hookah pipe with running water after each smoking session; wash all holes and threaded connections no more than once a month with daily smoking; dry the hookah well after washing.

Happy using!